We use cookies to give you the best customer experience possible. If you continue to use our web, we will assume that you agree to the use of such cookies.

 

Jawa parts shop in Zlin (CZ)

 




Introduction » Parts SIMSON » Ignition-Electrical » Contactless ignition VAPE-Simson 12V


        

Contactless ignition VAPE-Simson 12V

STOCK

 

Product no.: 1914
Discount coupon can not be used
Our Price without Tax : 233.20 EUR
Our Price including Tax (21 %):
282.17 EUR

into the basket:
  ks  
Watchdog

Full specifications

Contactless ignition VAPE-Simson 12V S51,Enduro Elektronik,Scooter

Complete Set of ignition,spark-coil, Part of Set is electrical wiring harness. All together you connect without probHems. Part of Set is connection diagram

Installation Instructions for Set SZ 10 -Simson S 51.

Set of ignition SZ 10 is designated as REPLACEMENT the original ignition, lighting and charging system. If you do not have professional knowledge, you entrust the installation to specialized service.

Removing original system:

Disconnect the battery, remove the RIGHT engine cover,rotor and stator of ignition, induction coil and other components of the original charge and the ignition system. If you have a motorcycle with 6-volt installation, it is necessary to replace the appliances and 12-volt battery.

Installation of new Set:

1/In place of the original stator install stator A70S-3 so, that cabling through the initial hole in the engine block towards the box with the switching cabinet. Stator attach the original handles and is pulled gently so that they could be rotated with him. On the carrier of the stator is at the top LEFT guideline, that must be correctly fitted stator overlap with the original guideline for adjusting the ignition to the engine block.

2/Put the rotor A70R-3-C on the Crankshaft (correct groove is designated "Simson OK") and tighten it to specified torque nut.

3/ignition timing perform so that the piston Set 1,4-1,8 mm before top dead centering(see. instructions for the typee of motorcycle).The rotor is gripped hands in position and move the stator so, as to overlap the groove on the rotor with a groove on the stator. In this position, tighten the screws and lock the stator is Set to advance.

4/Mount the spool Z 71 instead of the original inductor, or on the battery into the LEFT clipboard. We always take care that the bobbin holder properly grounded.

5/Mount regulator R54 to LEFT clipboard. Brown wire from the regulator connected to under the screw holding the regulator and the second contact to a common ground in the clipboard.

6/Cabling, which is part of Set connect to stator coil and regulator. Cabling we lead so could not result in the operation of mechanical damage.

7/Connect the cables to the switch box as follows:

a/blue wire to contact n.2

b/red wire through eyelet on plus pole connector on the Battery and contact n.30.

c/yellow wire on n.59

8/Recheck all ground-mounted components.

OTE2M2Y
Watchdog
Watch DOG


Inform via email when change of:


       when the price is lower than EUR

        when the product is on stock


Fill in your emaill: