Carburetor intake elbow Dellorto 16.16SHA, FORWARD - Babetta 210

Full specifications

Carburetor intake elbow Dellorto 16.16SHA, FORWARD - Babetta 210

Manufacturer description:

Intake elbow for Dellorto D16 carburetor (16.16SHA) on Babetta 210, 215 and 225. It fits without the need for any modifications. When using this elbow with a carburetor, you will achieve better reliability, the possibility of better adjustment and also better performance thanks to a larger amount of intake.

The elbow is slightly turned to the left so that there is no collision of the throttle cable and the frame.

• inner diameter of suction elbow 16mm, outer 20mm
• carburetor flange diameter 19mm
• flange fits on the original pitch of the grafts, hole in the cylinder diameter 16mm
• gap between carburetor and cylinder approx. 10mm
• material stainless steel - SANDBLASTED (BALLOTINATED SURFACE)

The knee differs from the original knee by its inner diameter. When using a dellorto 16SHA carburetor, it is necessary to use an intake with the same diameter - 16 mm for the correct result. The original elbow 12mm effect DO16 suffocates and the adjustment would not make sense.

For use on the original cylinder, we recommend nozzle 58, 60, 62 (must be tried) and side suction with 3 tubes

It can also be used for dellorto - 14mm replica carburetors, it is only necessary to adjust the sealing ring in the carbecula flange by turning it from a diameter of 18mm to 19mm or to replace the ring with an original one from dellorta.

The advantage is also a tightly welded flange, ie. there is no need for a screw flange which is supplied with the carburetor in the package, it happens that it breaks in connection.

The complete set includes: suction elbow, stainless steel nuts, washers and sockets for mounting.